How to setup and flash 4th Gen Dichen Fuser guide
Setup guide for 4th Gen Dichen Fuser hardware. Flash firmware and configure EDID spoofing for your display.
What is a Fuser?
A Fuser sits between your GPU and monitor, allowing your cheat PC to overlay ESP graphics directly onto your game display without needing a second monitor. It also handles EDID spoofing to prevent detection.
4th Gen Dichen Specs
The 4th Gen Dichen Fuser features:
- •4K60Hz HDR passthrough support
- •Built-in EDID spoofing
- •Low latency overlay mixing
- •USB 3.0 capture output
- •Firmware update capability
ℹHardware Installation
Disconnect your monitor from GPU. Connect GPU HDMI/DP output to Fuser input. Connect Fuser output to your monitor. Connect Fuser USB to your cheat PC.
⚠Firmware Flashing
WARNING: Incorrect firmware can brick your device. Download firmware only from official sources. Never disconnect power during flashing process.
Flash Process
To flash firmware:
- •Disconnect all cables from Fuser
- •Hold reset button while connecting USB
- •Device appears as USB storage drive
- •Copy .bin firmware file to the drive
- •Safely eject and reconnect - flash happens automatically
💡EDID Configuration
EDID spoofing makes your GPU think it's connected directly to your monitor. Use the Fuser configuration tool to copy your monitor's EDID data to the device. This prevents games from detecting the capture device.
Troubleshooting Black Screen
If you see a black screen: Try different HDMI/DP cables, ensure correct input/output ports, check EDID settings match your monitor, try a different resolution temporarily.
Still stuck? Open a ticket on Discord
All Guides